Figure 2-12. Removing The Display - HP Omnibook XE3 Service Manual

Screws,
M2.5x4 mm (2)
Reassembly Notes
While installing the hinge screws, support the display so that it remains approximately flat.
Before installing the switchboard PCA, make sure the large display cable lies within the notch in
the hinge saddle.
When installing a new display assembly, follow the procedure given in "Installing a New Display
Assembly" on the following page.
HP Omnibook XE3 (Technology Codes GE and GD)
Screws (flanged)
M2.5x8 mm (4)

Figure 2-12. Removing the Display

Removal and Replacement 2-19