HP Omnibook XE3 Service Manual page 63

Component
Keyboard
PCA, CD player
PCA, headphone
PCA, motherboard
PCA, switchboard
PCA, video
Saddle, hinge set
Socket, PCMCIA
HP Omnibook XE3 (Technology Codes GE and GD)
Removal Procedure
See page 2-12.
See page 2-24.
Keyboard cover
(page 2-10).
Keyboard (page 2-12).
Display assembly
(page 2-18).
Top case (page 2-22).
Hinge saddle set
(page 2-25).
See page 2-35.
Keyboard cover
(page 2-10).
Keyboard (page 2-12).
See page 2-27.
See page 2-25.
Keyboard cover
(page 2-10).
Keyboard (page 2-12).
Display assembly
(page 2-18).
Top case (page 2-22).
Hinge saddle set
(page 2-25).
Additional Steps
Remove the retaining screw from the PCA, disconnect
the cable to the motherboard, and lift the PCA out of
the notebook. You can lift the floppy drive slightly for
access.
Remove both screws (M2.5x4 mm) from the PCA, and
carefully lift the PCA off of the connector beneath it. Be
careful not to pull on the cable attached to the PCA.
Disconnect the cable from the PCA and remove the
PCA from the notebook.
Remove the four screws attaching the PCMCIA socket
to the motherboard (M2.5x5 mm), and remove the
socket.
Removal and Replacement 2-41