Table of Contents
Advertisement
3.
Remove the battery from the computer (3).
To install the battery, reverse the removal procedures.
Display subcomponents (without removing the display)
You can remove some display subcomponents without removing the entire display assembly from the
computer. To remove the display panel and camera module, use these procedures and illustrations.
To remove display subcomponents that require that you remove the display from the computer, see
Display assembly on page
Before removing the display subcomponents, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Disconnect the battery cable from the system board (see
Remove the display assembly subcomponents:
NOTE:
The display assembly can remain attached to the computer for these procedures.
1.
To remove the display panel:
a.
The display panel is secured to the display enclosure with tape that is installed under the left
and right sides of the panel. The top of the panel is secured to the rear cover only with hooks.
To remove the panel, use a tool (1) to pry the top of the panel away from the top of the display
rear cover.
49.
Preparation for disassembly on page
Bottom cover on page
Display subcomponents (without removing the display)
30).
Battery on page
31).
30).
33
Advertisement
Table of Contents
