Figure 2-7. Removing The Keyboard Cover - HP Omnibook XE3 Service Manual

Reassembly Notes
Tuck the display cables into the notch just to the right of the left display hinge.
Hold the cover by the hinge covers, bow the center upwards slightly, and snap it into place. This
may be easier if you bow the center of the panel upwards slightly as you install it. Note the cover's
retaining tabs at the left and center of the cover's bottom edge, and at its upper left and right
corners. Make sure these tabs snap back into place when reinstalling the cover.
HP Omnibook XE3 (Technology Codes GE and GD)

Figure 2-7. Removing the Keyboard Cover

Removal and Replacement 2-11