Display Subcomponents (Without Removing The Display) - HP Spectre x360 Maintenance And Service Manual

IMPORTANT:
information. To prevent loss of information, save your work or shut down the computer through
Windows before you remove the battery.
Remove the battery:
1. Disconnect the battery cable (1) from the system board.
2. Remove the eight Phillips M2.0 × 3.5 screws (2) that secure the battery to the computer.
3. Remove the battery from the computer (3).
To install the battery, reverse the removal procedures.

Display subcomponents (without removing the display)

You can remove some display subcomponents without removing the entire display assembly from the
computer. To remove the display panel, camera module, and touch board, use these procedures and
illustrations.
To remove display subcomponents that require that you remove the display from the computer, see
Display assembly on page
Before removing the display subcomponents, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board (see
Remove the display assembly subcomponents:
NOTE: The display assembly can remain attached to the computer for these procedures.
1. To remove the display panel:
Removing a battery that is the sole power source for the computer can cause loss of
43.
Bottom cover on page
Preparation for disassembly on page
32).
Battery on page
Display subcomponents (without removing the display)
32).
34).
35