Figure 2-19. Removing The Video Pca - HP Omnibook XE3 Service Manual

4. Remove all three retaining screws from the PCA, and carefully lift it off of the connectors
underneath it.
Reassembly Notes
Set the DIP switches on the new PCA to match the settings from the PCA you are replacing and
the notebook's display type. See the settings tables on page 2-20.
Make sure the protective pads on the PCA are intact, and replace if needed.
Make sure the PCA is firmly set on its connectors.
2-28 Removal and Replacement
Screws,
M2.5x4 mm (3)

Figure 2-19. Removing the Video PCA

HP Omnibook XE3 (Technology Codes GE and GD)