Figure 2-5. Removing The Mini-Pci Pca - HP Omnibook XE3 Service Manual

Reassembly Notes
Reattach the cable (modem models only) or cables (modem/LAN models only) to the PCA, and
tuck them into the compartment.
Gently press the PCA into the connector at an angle of about 30°, until it is fully inserted. Then
press down on both sides of the PCA until the latches snap closed.
Make sure sticky pads on the underside of the PCA are intact. Replace if needed.
2-8 Removal and Replacement

Figure 2-5. Removing the Mini-PCI PCA

HP Omnibook XE3 (Technology Codes GE and GD)