Shindaiwa DGW310DMC Owner's Manual page 36

2) Change Oil Filter
1st
nd
2 or after
1 Drain the oil as described in
( 1)Change Engine Oil
『
2 Remove the oil filter using an oil filter wrench.
3 Smear a little engine oil on the rubber gasket of a new filter.
4 Screw the new filter into place and tighten it by
Hand until the gasket contact seat. Then give it
additional 1.1/4 turns using an oil filter wrench.
5 Supply engine oil.
C aution
＜ ＜ ＜ ＜ ＞ ＞ ＞ ＞
●If an oil filter wrench is not available to get, contact our authorized
distributor or our service section to change.
●Oil Filter Part No.:15853-32433 (Kubota)
●After supplying engine oil, keep the engine drive for
a while to check no engine oil leakage and then stop the engine
(3) Clean/Change Air Element
Clean
Change
1 Loosen the wing bolts in the cleaner and
remove the air element.
2 Clean or replace the air element.
D ried contaminants adhere
＜
Blow up compressed air from inside
the element.
C arbon or oil adhere
＜
Replace to a new one.
3 Reinstall it in reverse order.
At 50 hrs
Every 200 hrs
.
』
st nd
1 at 50 hrs 2 or after 100 hrs
Every 400 hrs
＞
＞
Air Cleaner
Air element
34
Oil filter
Gasket
Clip ﾟ
Air Cleaner cap
Clip ﾟ