Shindaiwa DGW310DMC Owner's Manual page 25

8-2. Polarity
There are 2 welding output terminals
Select the polarity according to the operation, referring to the table below.
C aution
＜ ＜ ＞ ＞
＜ ＜ ＞ ＞
●Welding Rods
Normal
Reverse
8-3. Connection – Welding Cable
Danger: Electric Shock
● Before connecting or disconnecting welding cable to terminal, stop the engine and
Remove the engine key. A person performing should always keep the key.
1. Stop the engine
2. Connect a cable to a crimping terminal, a rod holder and
a material holder.
3. As to DGW310DMC, connect the cable
referring the chart below.
ECO (Single)
Rod
Φ2.0 φ 4.0
～
Welding Output
Terminal A
C aution
＜ ＜ ＞ ＞
＜ ＜ ＞ ＞
●Be sure to crimp a crimping terminal to a cable and connect the cable to welding cable to welding
output terminal. Otherwise the terminal may burn out by the heat due to insufficient connections.
● Use a cable with a crimping terminal. To weld binding bare wires to an output terminal, the terminal
may burn out by the heat caused by insufficient connections and also bare wires may touch the
bonnet to bring short-circuit.
+ a nd
『 』
Application
General Welding such as
construction
Thin Plate, Build-UP Welding
Stainless Steel
Single
Rod
Φ2.6 φ 6.0
～
Welding Output
Terminal A
-
.
『 』
Connection
- to Holder (Rod)
+ to Earth (Material)
- to Earth (Material)
+ to Holder (Rod)
Dual
Rod
Φ2.0
～
Welding Output Terminal
Welding Output Terminal
23
Rod Holder
Holder
φ 4.0
A
&
B
Cable
Crimping terminal