C Hecking Battery - Shindaiwa DGW310DMC Owner's Manual

Generator/welder vertical, water-cooled 4-cycle diesel engine
Hide thumbs Also See for DGW310DMC:
Table of Contents

Advertisement

6-5 Battery
Caution: Injuries to eye and skin
● Battery Fluid contains diluted sulfuric acid. Avoid contact
with eyes, skin or clothing.
● If the acid comes to contact, especially with eyes, flush with a lot of water and contact to a doctor
immediately.
Caution: Explosion
● Do not use the equipment or charge the battery in the case battery
Fluid level is lower than the LOWER level.
● Battery emits some combustible gas, so keep it away from fire and spark.
1. Check the fluid level. If the level is near or
lower than the LOWER level, add distilled
water until the fluid level reaches UPPER.
2 Make sure that the battery cables are firmly
secured to the posts.
Tighten the clamps if it is necessary.
C aution
● Check the hydrometer of the battery fluid. If it falls below 1.23, the battery requires recharging. Consult
with our authorized distributor or our service department.
■Replacing battery
1. Remove the under plate.
(M6 bolt x 2)
2. Remove the cable on
(Always on
3. Remove the battery fixing plate.
4. Remove the cable on
5. Remove the battery.
Reinstall a new battery in the reverse order.
(Install always the cable to the
C aution
● Use the following battery.
● When replacing a battery, remove the under plate firstly. Otherwise the battery slanted and the fluid
may leak and contact to eye or skin.
-
s ide.
+
s ide first)
+
s ide.
+
p ositive post first in a new battery.
4 6B24L
Lower level
Fix Plate
Ins Cap
+ terminal
19
Terminal
Terminal
Under Plate
Upper level

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dgw310mc

Table of Contents