5. Incorporated
5-1. Eco Welding
The equipment is incorporated in Eco Welding Feature that is aiming at performing
The low noise, the lower fuel consumption and the low gas emission than those of conventional models.
When you turn the selector switch to Eco, you will be able to weld with Max 4.0mmφ rod at the slow
down speed.
C aution
<
<
>
>
<
<
>
>
●When welding is performed, do not turn the output selector switch which causes the burnout of the
switch
●Eco is designed for welding only. The breaker activates to TRIP, in case it is used for AC Output
5-2. Display
The equipment is incorporated in Digital Display. It displays
by changing the display selector switch.
C aution
<
<
<
<
>
>
>
>
●During operation, voltage meter always displays the voltage in 200/220V, 3-Phase both at the
breaker position
5-3. Frequency Selection
Selector either 50 or 60Hz by the selector switch on the front panel, in accordance with the load
frequency.
5-4. Monitor Lamp
The equipment incorporates monitor lamps as
Pressure
.
』
Under normal condition, when the starter switch is turned from
CHARGING
a nd
』
When abnormality happens in running, monitor lamps flicker
And the engine stops automatically.
In the case the automatic shutdown is engaged, turn the starter switch to STOP once, and then restart
the engine. When the automatic shutdown is engaged again, check which lamp turns ON or OFF and
point out where the abnormality is.
O N
and
O FF
『
』
『
O IL Pressure
turned To ON and all the lamps turn to OFF after the Engine starts.
『
』
Water Temp
V oltage
『
.
』
W ater Temperature
『
『
Charge
10
,
H our
,
S peed
』
『
』
『
,
B attery Charging
』
『
S TOP
to
R EN
, the lamps of,
』
『
』
Oil Pres
Preheat
s uccessively,
』
and
O il
』
『
B ATTERY
『