Shindaiwa DGW310DMC Owner's Manual page 31

C aution
＜ ＜ ＞ ＞
＜ ＜ ＞ ＞
●The AC volt meter reads 3-P 200/200V apart from the circuit breakers position at
when the engine driving.
After the engine starts
1 Turn the power switch off on the load.
2 Check and confirm the breakers position at
3 Select the correct frequency, designated in the loads.
4 Connect the loads to receptacle or terminals.
5 Close the terminal cover and fix it with the bolts.
6 Turn the breakers to
DMC
3-P/1-P 200/220V
Output Terminals
Breaker Receptacle
■ Return -The circuit breaker has activated due to overload
Caution: Injuries
●Be sure to turn the power switch to OFF on the load when returning the circuit breaker to ON again,
when the circuit breaker has activated.
When the electric supply exceeds the rated output, the breaker activates to trip in order to shut down the
circuit. Check the breakers when the load stops operation.
ELCB lamp is to turn OFF in the case of overload shutdown. When the lamp keeps ON, refer to
ELCB and Grounding
When any breaker has activated, return the circuit breaker per the followings procedure.
1 Turn OFF all the power switches on the loads.
2 Once push down the breaker lever to
C aution
＜ ＜ ＜ ＜ ＞ ＞ ＞ ＞
●Take care for overload, referring to
●The breaker activates when having used AC output in the selector switch at
case stop using AC supply and return the breaker as above.
R efer to 7 -1.Starting
（ 『
O N .
『 』
1-P 100/110V
Output Terminals
Terminal
Cover
.
』
『
9 -2 Output Limitation
『
, operate as per the following procedures.
』
O FF .
『 』
Output
Terminal
MC
Cover
Breaker
1-P 100/110V
Output Terminals
1-P/3-P
200/220V
Output
Terminals
O FF , push up the lever to
』
』
29
O N
『
Receptacle
O N .
『 』
E CO position. In the
『 』
or O FF
』 『 』
5 -6.
『