Shindaiwa DGW310DMC Owner's Manual page 23

Generator/welder vertical, water-cooled 4-cycle diesel engine
Hide thumbs Also See for DGW310DMC:
Table of Contents

Advertisement

7. Keep the engine idle for about 5 minutes.
Slow-down switch
Breaker
■Restarting after stopping due to fuel shortage
This equipment is incorporated in automatic vacuuming air feature. Therefore, even though the engine
stops due to fuel run out, you can restart the engine easily by the following steps.
1. Turn the breakers to
2. Turn the starter switch to
3. Fill the fuel.
4. Turn the slow-down switch to
5. Turn the starter switch to
6. Release the starter switch, promptly as the engine started.
7. Wait for about 1 minute to vacuum the air out. The engine peed becomes stable when the air is
extracted.
C aution
● Never turn the engine NORMAL speed or connected the loads until the air is extracted completely (until
the engine becomes stable).
Starter
O FF
S TOP
.
O N
.
S TART
a nd drive the starter motor for about 10 seconds.
Fuel lever
Close
Open
21

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dgw310mc

Table of Contents