Installing A Hard Disk Drive In Bay 5 - IBM IntelliStation M Pro 6225 Hardware Maintenance Manual And Troubleshooting Manual

10. Route the signal cable so that it does not block the airflow to the rear of the
11. If you have another drive to install or remove, do so now.
12. Connect the power cable to the back of the drive. The connectors are keyed
13. If you have other options to install or remove, do so now; otherwise, replace

Installing a hard disk drive in bay 5

Bay 5 is inside the computer below the power supply within a drive cage.
Note: When installing options, you might find it easier to work with the computer
Before you install a hard disk drive in bay 5, read the following information:
v Read the documentation that comes with the drive for cabling instructions.
v Route the cable before you install the drive. Do not block the airflow from the
Complete the following steps to install a drive in bay 5:
50
IntelliStation M Pro Types 6225 and 6228: Hardware Maintenance Manual and Troubleshooting Guide
v To install a drive in bay 3 or 4, complete the following steps:
Note: Only a 3.5-in. device can be installed in bay 3 or 4.
– If you are installing an external media device, complete the following
steps:
a. Remove the small drive clip that is attached to the bottom of the drive
cage for bays 1, 2, 3, and 4 (see the figure in step 5). Slide the drive
clip to disengage it from the drive cage; then, snap the drive clip into
the screw holes on the side of the drive.
b. Slide the drive into the drive bay until it snaps in place.
– If you are installing a hard disk drive, complete the following steps:
a. Push the drive into the bay from the rear of the drive cage.
b. Use the two screws to attach the drive to the drive cage.
9. Determine whether the drive is an IDE, SATA, or SCSI device; then, connect
one end of the applicable signal cable into the back of the drive and make
sure that the other end of this cable is connected into the applicable IDE,
SATA, or SCSI connector.
drives or over the microprocessor.
and can be inserted only one way.
the bezel (see "Removing and Installing the Bezel" on page 34).
lying on its side.
fans.
1. Read Appendix B, "Safety information," on page 115, the guidelines in
"Handling static-sensitive devices" on page 29.
2. Turn off the computer and all attached devices (see "Turning off the computer"
on page 6); then, disconnect all external cables and power cords.
3. Remove the side cover (see "Removing the side cover" on page 32).
4. Push the drive-cage retention latch toward the front of the computer and hold
the latch in place. While holding the latch in place, grasp the drive-cage handle
and rotate the cage until it locks into place with the drive-cage retention latch.
The installed drive will face you.
Note: As you rotate the drive cage, make sure the hard disk drive cables or
other internal cables do not impede the rotation of the drive cage.