IBM IntelliStation M Pro 6225 Hardware Maintenance Manual And Troubleshooting Manual page 107

Error code/symptom
1806
(PCI-to-PCI bridge error occurred.)
1807
(xxxxyyyy PCI device unresponsive or
disabled by user, where xxxx=PCI vendor
ID and yyyy=PCI device ID.)
1808
(Unsupported PCI device is installed.)
1962
(Drive does not contain a valid boot
sector)
5962
(IDE CD-ROM drive configuration error)
8603
(Pointing-device error)
00012000
(Machine check architecture error.)
00180700
(PCI device not responding.)
I9990650
(AC power has been restored)
FRU/action
1. Remove all adapters and reinstall one at a time, restarting the
server each time, until the failing adapter is determined; then,
replace that adapter.
2. System board.
1. Run the Configuration/Setup Utility program and make sure the
device is enabled.
2. Adapter.
3. System board.
1. Remove all adapters and reinstall one at a time, restarting the
server each time, until the failing adapter is determined; then,
replace that adapter.
2. System board.
1. Verify that a startable operating system is installed.
2. Run diagnostics.
3. Hard disk drive.
4. SCSI adapter, if installed.
5. Cable.
6. System board.
1. Run the Configuration/Setup Utility program.
2. CD-ROM drive.
3. CD-ROM power cable.
4. IDE cable.
5. System board.
6. Battery.
1. Pointing device
2. System board
1. Microprocessor
2. System board
1. System board
2. PCI adapter
1. Check cable.
2. Check for interruption of power.
3. Power cable.
Chapter 6. Symptom-to-FRU index
97