IBM IntelliStation M Pro 6225 Hardware Maintenance Manual And Troubleshooting Manual page 62

10. Determine whether the new drive is a SATA or SCSI device; then, connect one
11. Route the signal cable so that it does not block the airflow to the rear of the
12. Route the signal cable so that it does not block the airflow to the rear of the
13. Connect the power cable to the back of the drive. The connectors are keyed
14. Push the drive-cage retention latch toward the front of the computer; then,
15. If you have other options to install or remove, do so now.
52
IntelliStation M Pro Types 6225 and 6228: Hardware Maintenance Manual and Troubleshooting Guide
8. Attach the new drive to the drive tray. Place the drive on the drive tray and
align the holes on the drive with the mounting pins on the drive tray. Gently
pull both sides of the drive tray outward and insert the mounting pins into the
holes on the drive.
9. Align the drive assembly with the guide rails in the bay (make sure that the
connector end of the drive is facing you).
end of the applicable signal cable into the back of the drive and the other end
of this cable into the applicable SATA or mini-PCI SCSI connector. See "Power
and signal cables for internal drives" on page 53 for additional information
about cabling drives and "System board option connectors" on page 77 for the
location of SATA and mini-PCI SCSI connectors on the system board. If there
are open connectors on the cables that connect existing SATA or SCSI drives,
these cables can be used to connect the new drive.
drives or over the microprocessor.
drives or over the microprocessor.
and can be inserted only one way.
rotate the drive cage back into the computer.
Note: As you rotate the drive cage, make sure the hard disk drive cables or
other internal cables do not impede the rotation of the drive cage.