Hot-Swap Power-Supply Led Errors - IBM IntelliStation Z Pro 6223 Hardware Maintenance Manual And Troubleshooting Manual

Note: See Chapter 7, "Parts listing Types 6223 and 6227," on page 115 to determine which components are
replaceable by the customer (CRU), and which components must be replaced by a field service technician (FRU).
Symptom
The ServerGuide program will
not start the operating-system
CD.
The operating system cannot be
installed; the option is not
available.
Note: See Chapter 7, "Parts listing Types 6223 and 6227," on page 115 to determine which components are
replaceable by the customer (CRU), and which components must be replaced by a field service technician (FRU).
Symptom
Suspected software problem.

Hot-swap power-supply LED errors

Use the information in this section to solve power-supply problems.
Note: The minimum configuration required for the dc good light to be lit is:
Note: See "System replaceable units" on page 117 to determine which components should be replaced by a field
service technician.
AC good DC good
LED LED
Off Off
ServerGuide Setup and Installation CD
FRU/action
v Verify that the operating-system CD you have is supported by the
ServerGuide program. See the ServerGuide Setup and Installation CD label for
a list of supported operating system versions.
v Verify that the operating system is supported on the computer. If the
operating system is supported, either there is no logical drive defined (SCSI
RAID systems) or the ServerGuide System Partition is not present. Run the
ServerGuide program, and ensure that setup is complete.
FRU/action
1. To determine if problems are caused by the software, verify that:
v The computer has the minimum memory needed to use the software. For
memory requirements, see the information that comes with the software.
Note: If you have just installed an adapter or memory, you might have a
memory address conflict.
v The software is designed to operate on the computer.
v Other software works on the computer.
v The software that you are using works on another system.
If you received any error messages when using the software program, see the
information that comes with the software for a description of the messages and
suggested solutions to the problem.
2. If you have verified these items and the problem remains, contact the place of
purchase.
v Power supply
v Power cage assembly, if installed.
v System board (press SW2 to bypass the power switch; see "System board
jumpers and switches" on page 75).
Description FRU/action
No power to system or
1. Check ac power to the system.
ac problem.
2. Power supply.
Software
Chapter 6. Symptom-to-FRU index
103