8.3
Installing a BBU
V
CAUTION!
Do not connect the cable using excessive force, the connector is
weak.
Follow the safety instructions in the
page
19.
Ê Open the server as described in
Ê Remove the air duct as described in the
page 30
Preparing a BBU module
Ê Connect the cable from the battery to the board.
Figure 71: Connecting the cable from the battery to the board
RX300 S6
chapter "Safety instructions" on
section "Opening the server" on page
section "Removing the air duct" on
Options Guide
Installing a BBU
29.
95