Fujitsu PRIMERGY RX300 S6 Options Manual page 65

Figure 35: Connecting the SATA cable to the system board
Ê Route the cable into the cable guide.
Ê Connect the SATA cable to the connector SATA1 on the system board (see
the cabling plans in the
Ê Replace the fan box (see
Ê Close the server, connect it to the power outlet, and switch it on as described
in the chapter "Completion" on page
RX300 S6
chapter "Appendix" on page
section "Installing a fan box" on page
115.
Options Guide
Installing an optical drive
123).
115).
65