Replacing The Processor - Fujitsu PRIMERGY RX300 S6 Options Manual

6.2

Replacing the processor

V
CAUTION!
Only identic processors may be used on the system board. The second
processor must have the same clock frequency and the same cache as
the first processor. For dual operation, use a suitable multiprocessor
operating system.
I
Install the heat sink as described in the sections
on page 47
Ê Open the server as described in
Ê Remove the air duct over the main memory and processors (see
"Removing the air duct" on page
Figure 21: Removing the heat sink
Ê Open the two heat sink retention levers at the same time.
Ê Loosen the heat sink by turning it back and forth and then lift it out.
Ê Remove the residual thermal paste from the underside of the heat sink.
Ê Clean the underside of the heat sink using a lint-free cloth.
RX300 S6
and "Replacing the heat sink" on page
Options Guide
Replacing the processor
chapter "Preparation" on page
30).
"Installing the heat sink"
52.
27.
section
49