Fujitsu PRIMERGY RX300 S6 Options Manual page 51

Figure 23: Inserting the processor
Ê Position the new processor over the socket and then carefully press it into
the socket.
V
CAUTION!
The processor can only be installed in one particular direction. Pay
attention to the marking on one of the corners and the socket coding.
To avoid damaging the connections (pins) or the processor, do not
force it into the socket.
Ê Lock the processor into the socket by closing the processor holder and
returning the socket release lever to its original position.
Ê Apply a small amount of thermal paste to the upper side of the new
processor.
Ê Ensure that the thermal paste is spread thinly and evenly. Refer to the
instruction sheet supplied with the thermal paste.
Ê Place the heat sink on the processor socket (see
page 47).
RX300 S6
Options Guide
Replacing the processor
"Installing the heat sink" on
51