Replacing the heat sink
Figure 24: Installing the heat sink
Ê Close the two heat sink retention levers at the same time.
Ê Replace the air duct over the main memory (see
duct" on page
Ê Close the server, connect it to the power outlet, and s witch it on as described
in the
chapter "Completion" on page
6.3
Replacing the heat sink
Ê Open the server as described in
Ê Remove the air duct over the main memory and processors (see
"Removing the air duct" on page
Ê Open the two heat sink retention levers at the same time (see
"Replacing the processor" on page
Ê Loosen the heat sink by turning it back and forth and then lift it out.
Ê Clean the upper side of the processor using a lint-free cloth.
Ê Remove the protective cover from the new heat sink.
52
118).
Options Guide
section "Inserting the air
115.
section "Opening the server" on page
30).
49).
RX
29.
section
section
300 S6