Figure 67: Installing a controller
Ê Install the expansion card into the PCI slot and press it carefully into the
associated plug-in location on the system board.
Ê Secure the slot cover with the screw.
Ê If required, connect the cables to the system board or other components.
Ê Close the server, connect it to the power outlet, and switch it on as described
in the
chapter "Completion" on page
8.2
Upgrading a SAS/SATA RAID controller
I
A SAS/SATA RAID controller is required for operating internal hard disk
drives. A SAS/SATA RAID controller is available for this purpose.
Ê Open the server as described in
RX300 S6
Upgrading a SAS/SATA RAID controller
115.
chapter "Preparation" on page
Options Guide
27.
91