Expanding The Main Memory - Fujitsu PRIMERGY RX300 S6 Options Manual

Expanding the main memory

5.2 Expanding the main memory
Ê Open the server as described in
Ê Remove the air duct over the main memory (see
page 30).
Figure 10: Removing a memory module
Ê Press the securing clips on both sides of the memory slot concerned
outward (1).
Ê If the slot was equipped: pull the memory module out of the slot (2).
V
CAUTION!
Please note the population rules in the Technical Manual for the system
board D2619-N.
Figure 11: Inserting a memory module
Ê Carefully press the memory module into the slot (1) until the securing clips
on both sides of it engage (2).
Pay attention to the plug coding.
38
chapter "Preparation" on page
Options Guide
RX
27.
"Removing the air duct" on
300 S6