Fujitsu PRIMERGY RX300 S6 Options Manual page 48

Installing a second processor
Figure 20: Closing the heat sink retention levers
Ê Close the two heat sink retention levers at the same time.
Ê Engage the two heat sink retention levers.
V
CAUTION!
Never install a processor without a heat sink. Doing so may cause the
processor to overheat. This will switch the system off and damage the
processor.
Ê Replace the air duct over the memory and processors (see
duct" on page
Ê Close the server, connect it to the power outlet, and s witch it on as described
in the chapter "Completion" on page
48
118).
Options Guide
115.
RX
"Inserting the air
300 S6