Expanding The Main Memory - Fujitsu PRIMERGY TX300 S6 Options Manual

Expanding the main memory

5.2 Expanding the main memory
Ê Open the server and remove the fan carrier as described in the
"Preparation" on page
Figure 13: Removing a memory module
Ê Press the securing clips on both sides of the memory slot concerned
outward (1).
Ê If the slot was equipped: pull the memory module out of the slot (2).
Figure 14: Installing a memory module
Ê Carefully press the memory module into the slot (1) until the securing clips
on both sides of it engage (2).
Ê Reinstall the fan carrier as described in the
on page 105.
Ê Close the server, connect it to the power outlet, and switch it on as described
in the chapter "Completion" on page
40
27.
105.
Options Guide
section "Installing the fan carrier"
Main memory
chapter
TX300 S6