Reinstalling The Blower Module - Cisco XR 12410 Installation Manual

Reinstalling Components After Installing the Chassis

Reinstalling the Blower Module

Step 1
Caution
Figure 3-22 Installing the Blower Module
Cisco XR 12410 Router Installation Guide
3-30
Use the following procedure to reinstall the blower module in the chassis.
Install the blower module into the chassis
Lift the blower module (with two hands) and slide it halfway into the module
a.
bay.
Slowly push the blower module into the chassis until it mates with the
b.
backplane connector at the back of the module bay.
To prevent damage to the connectors, do not use excessive force when inserting
the blower module into the chassis.
Tighten the captive screws on the blower module to secure it to the chassis.
c.
Chapter 3 Installing the Cisco XR 12410 Router
(Figure 3-22):
OL-13832-01