Table of Contents
Advertisement
Chapter 3
Installing the Cisco XR 12410 Router
Step 2
Reinstalling Components After Installing the Chassis
Reinstalling Power Supplies
OL-13832-01
Prepare the other end of the grounding wire and connect it to the appropriate
grounding point at your site to ensure an adequate earth ground.
This section describes how to reinstall the components that you removed before
installing the chassis in the rack. It also describes how to reconnect cables to line
cards, the RP, and alarm cards.
Use the following procedures to reinstall the AC or DC power supplies.
To reinstall AC PEMs, go to
•
To reinstall DC PEMs, go to
•
Reinstalling Components After Installing the Chassis
Reinstalling AC PEMs, page 3-28
Reinstalling DC PEMs, page 3-29
Cisco XR 12410 Router Installation Guide
3-27
Advertisement
Table of Contents
Troubleshooting
