Reinstalling The Blower Module - Cisco 12410 Installation And Configuration Manual

Reinstalling Components After Installing the Chassis

Reinstalling the Blower Module

Step 1
Caution
Figure 3-23 Installing the Blower Module
Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide
3-32
Use the following procedure to reinstall the blower module in the chassis.
Install the blower module into the chassis
Lift the blower module (with two hands) and slide it halfway into the module
a.
bay.
Slowly push the blower module into the chassis until it mates with the
b.
backplane connector at the back of the module bay.
To prevent damage to the connectors, do not use excessive force when inserting
the blower module into the chassis.
Tighten the captive screws on the blower module to secure it to the chassis.
c.
Chapter 3 Installing the Router
(Figure 3-23):
OL-11496-01