Cisco XR 12410 Installation Manual page 89

Chapter 3 Installing the Cisco XR 12410 Router
Step 2
Figure 3-8 Removing a Line Card from the Line Card and RP Card Cage
a a Loosen Loosen
captive captive
screws screws
b b Pivot ejector Pivot ejector
levers away levers away
from card to from card to
unseat card unseat card
c c Grasp card carrier to Grasp card carrier to
slide card out of slot slide card out of slot
Step 3
OL-13832-01
Starting at slot 0:
Loosen the captive screws at the top and bottom of the front panel
a.
(Figure 3-8a).
Pivot the ejector levers to unseat the card from the backplane connector
b.
(Figure 3-8b.)
Slide the card out of the slot
c.
antistatic bag or other ESD-preventive container.
ALARM A
Repeat Step 2 for each line card.
(Figure 3-8c) and place it directly into an
MBUS CSC
SFC
A
ALARM A B FAIL
ALARM B
ENABLE
A B 0 1 0
1 2 3 4
ALARM B
Cisco XR 12410 Router Installation Guide
Removing Cards from the Chassis
3-13