Reinstalling Ac Pems - Cisco XR 12410 Installation Manual

Reinstalling Components After Installing the Chassis

Reinstalling AC PEMs

Step 1
Caution
Figure 3-20 Installing an AC PEM
PWR OK
FAULT
0
TEMP
ILIM
PWR OK
FAULT
TEMP
ILIM
Step 2
Step 3
Cisco XR 12410 Router Installation Guide
3-28
Use the following procedure to reinstall the AC PEMs back into the chassis.
Install the AC PEMs (Figure
Slide the power supply into the bay until it mates with its backplane
a.
connector.
Lift the ejector lever into place and tighten the captive screw to securely seat
b.
the power supply to the backplane connector.
To prevent damage to the power shelf backplane connector, do not use excessive
force when inserting the power supply into the chassis.
0
Repeat Step 1 for the other power supply.
Go to the "Reinstalling the Blower Module" section on page 3-30
blower module.
Chapter 3 Installing the Cisco XR 12410 Router
3-20):
to install the
OL-13832-01