Removing Components Before Installing the Chassis
Removing DC PEMs
Step 1
Warning
Step 2
Cisco XR 12410 Router Installation Guide
3-8
Use the following procedure to remove the DC PEMs from the chassis.
Remove the PEM from the chassis
Loosen the captive screw on the ejector lever.
a.
Pivot the lever down to eject the PEM from its bay.
b.
Slide the PEM out of its bay while supporting it with your other hand.
c.
The DC PEM weighs approximately 14 pounds (6.35 kg). Use two hands to
remove the power supply.
Figure 3-5
Removing a DC PEM
Repeat Step 1 for the other PEM.
Chapter 3
Installing the Cisco XR 12410 Router
(Figure
3-5):
OL-13832-01