Removing And Replacing The Blower Module - Cisco XR 12410 Installation Manual

Removing and Replacing the Blower Module

Step 2
Caution
Figure 5-6 Installing the Blower Module
Cisco XR 12410 Router Installation Guide
5-10
Install the new blower module into the chassis
Lift the blower module (with two hands) and slide it halfway into the module
a.
bay.
Slowly push the blower module into the chassis until it mates with the
b.
backplane connector at the back of the module bay.
To prevent damage to the connectors, do not use excessive force when inserting
the blower module into the chassis.
Tighten the captive screws on the blower module to secure it to the chassis.
c.
The (green) OK status indicator on the front of the blower module goes on. If
•
the OK indicator does not light, see the
Installation" section on page
Chapter 5
(Figure 5-6):
"Troubleshooting the Blower Module
5-11.
Maintaining the Router
OL-13832-01