Cisco XR 12410 Installation Manual page 71

Chapter 2 Preparing for Installation
Figure 2-13
•
•
Figure 2-13
(Cisco 12000
series router)
series router)
OL-13832-01
shows:
You cannot access Network 2.0.0.0 from Ethernet port (E0) on the PRP in
Router A. You can only access Host A, Host B, and Router C, which are in
Network 1.0.0.0 (see dotted-line arrows).
To access Network 2.0.0.0 from Router A, you must use an interface port on
one of the line cards (a POS line card in this example) in Router A. Data from
Router A is routed through Router B and Router C, to reach Network 2.0.0.0
(see solid-line arrows).
Using the Ethernet Port on the PRP
Router A
EO
POS
EO
Router B
(Cisco 7500
Network 1.0.0.0
Host A
Host B
Router C
(Cisco 7500
series router)
Cisco XR 12410 Router Installation Guide
PRP Port Connection Guidelines
Network 2.0.0.0
Host A
2-27