Line Card and Route Processor Overview
Line Cards
Caution
Note
Route Processor
Cisco XR 12410 Router Installation Guide
1-14
Ports and connectors on the line card front panels provide interfaces for external
connections. Line cards communicate with the RP and exchange packet data with
each other through the switch fabric cards.
Any unoccupied card slot in the line card and RP card cage must have a blank
filler panel installed to meet electromagnetic compatibility (EMC) requirements
and to ensure proper air flow through the chassis. Also, if the front panel of a line
card does not completely fill the card slot opening, a narrow card filler panel must
be installed to meet the EMC requirements.
A cable management bracket on the front panel of each line card helps to organize
the interface cables connected to that line card.
The Cisco XR 12410 router supports online insertion and removal (OIR),
–
allowing you to remove and replace a card while the router remains
powered on.
The following line cards, SIPs, and SPAs are supported on the Cisco XR 12410
router:
Refer to the current s software release notes for the most up-to-date list of
supported line cards (see
Security Guidelines" section on page
The route processor for the Cisco XR 12410 router is the Performance Route
Processor (PRP-2). For detailed information about the Performance Route
Processor, refer to the Cisco document, Performance Route Processor Installation
and Configuration Guide.
Chapter 1
"Obtaining Documentation, Obtaining Support, and
-xiv).
Cisco XR 12410 Router Overview
OL-13832-01