Installing Rack-Mount Brackets-Optional - Cisco XR 12410 Installation Manual

Rack-Mounting the Router Chassis
Installing Rack-Mount Brackets—Optional
Note
Step 1
Cisco XR 12410 Router Installation Guide
3-18
Figure 3-12 Verifying Equipment Rack Dimensions
Mounting flanges
Minimum usable
aperture 17.7 inches
(45.0 cm)
Hole centerline
to hole centerline
18.31 inches ± 0.06 inches
(46.5 cm ± 0.15 cm)
The router accessory kit ships with a pair of rack-mount brackets that can be used
as a temporary aid to bear the weight of the chassis while it is being positioned
and secured in the equipment rack. Using these mounting brackets is optional, but
highly recommended to make installation easier. The rack-mount brackets can be
left in place after the chassis is installed.
Before installing the rack-mount brackets, make sure you have performed the
measurements described in
Use the following procedure to install the rack-mount brackets.
Determine the location in which you want to position the chassis in the rack, and
mark holes at the same height on both the left and right rack rails.
Chapter 3
"Verifying Rack Dimensions" section on page
Installing the Cisco XR 12410 Router
OL-13832-01
3-17.