Front Panel; Front Panel Leds; Management Overview - ZyXEL Communications ZyWALL USG 300 User Manual

1.3 Front Panel

This section introduces the ZyWALL's front panel.
Figure 3 ZyWALL Front Panel

1.3.1 Front Panel LEDs

The following table describes the LEDs.
Table 1 Front Panel LEDs
LED
PWR
SYS
AUX
P1, P2, ...
Card1,2

1.4 Management Overview

You can use the following ways to manage the ZyWALL.
ZyWALL USG 300 User's Guide
COLOR STATUS DESCRIPTION
Off The ZyWALL is turned off.
Green On The ZyWALL is turned on.
Red On There is a hardware component failure. Shut down
the device, wait for a few minutes and then restart
the device (see
turns red again, then please contact your vendor.
Green Off The ZyWALL is not ready or has failed.
On The ZyWALL is ready and running.
Flashing The ZyWALL is restarting.
Green Off The AUX port is not connected.
Flashing The AUX port is sending or receiving packets.
On The AUX port is connected.
Green Off There is no traffic on this port.
Flashing The ZyWALL is sending or receiving packets on this
port.
Orange Off There is no connection on this port.
On This port has a successful link.
Green Off There is no card in the slot.
On There is a card in the slot.
Flashing The card in the slot is sending or receiving traffic.
Chapter 1 Introducing the ZyWALL
Section 1.5 on page 37). If the LED
35