Wlan Interface Station Monitor Screen - ZyXEL Communications ZyWALL USG 300 User Manual

10.9 WLAN Interface Station Monitor Screen

The station monitor displays the connection status of the wireless clients
connected to (or trying to connect to) a IEEE 802.11b/g card installed in the
ZyWALL.
To open the station monitor, click Monitor > System Status > WLAN Status.
The screen appears as shown.
Figure 240 Monitor > System Status > WLAN Status
The following table describes the labels in this menu.
Table 38 Monitor > System Status > WLAN Status
LABEL
Station
List
#
MAC
Address
Strength
Connect
Rate
Interface
Refresh
ZyWALL USG 300 User's Guide
DESCRIPTION
Select the location where the IEEE 802.11b/g is located.
This is the index number of the MAC address.
This displays the MAC address (in XX:XX:XX:XX:XX:XX format) of a
connected wireless station.
This displays the strength of the wireless client's radio signal. The signal
strength mainly depends on the antenna output power and the wireless
client's distance from the ZyWALL.
This displays what data transfer rate of the wireless client's connection to the
ZyWALL. This field displays up to the standard IEEE 802.11g connection rate
of 54 Mbps. It does not display higher, even if you enable super mode. The
display on your wireless clients may vary.
This is the name of the wireless LAN interface on the ZyWALL to which the
wireless client is connected.
Click this button to update the information in the screen.
Chapter 10 Monitor
253