ZyXEL Communications ZyWALL USG 300 User Manual page 359

Table 82 Configuration > Network > Interface > Bridge > Edit (continued)
LABEL
Add
Edit
Remove
#
IP Address
MAC Address
Description
Connectivity
Check
Enable
Connectivity
Check
Check Method
Check Period
Check Timeout Enter the number of seconds to wait for a response before the
Check Fail
Tolerance
Check Default
Gateway
Check this
address
Check Port
OK
Cancel
ZyWALL USG 300 User's Guide
DESCRIPTION
Click this to create a new entry.
Select an entry and click this to be able to modify it.
Select an entry and click this to delete it.
This field is a sequential value, and it is not associated with a specific
entry.
Enter the IP address to assign to a device with this entry's MAC
address.
Enter the MAC address to which to assign this entry's IP address.
Enter a description to help identify this static DHCP entry. You can use
alphanumeric and ()+/:=?!*#@$_%- characters, and it can be up to
60 characters long.
The interface can regularly check the connection to the gateway you
specified to make sure it is still available. You specify how often the
interface checks the connection, how long to wait for a response
before the attempt is a failure, and how many consecutive failures are
required before the ZyWALL stops routing to the gateway. The
ZyWALL resumes routing to the gateway the first time the gateway
passes the connectivity check.
Select this to turn on the connection check.
Select the method that the gateway allows.
Select icmp to have the ZyWALL regularly ping the gateway you
specify to make sure it is still available.
Select tcp to have the ZyWALL regularly perform a TCP handshake
with the gateway you specify to make sure it is still available.
Enter the number of seconds between connection check attempts.
attempt is a failure.
Enter the number of consecutive failures before the ZyWALL stops
routing through the gateway.
Select this to use the default gateway for the connectivity check.
Select this to specify a domain name or IP address for the
connectivity check. Enter that domain name or IP address in the field
next to it.
This field only displays when you set the Check Method to tcp.
Specify the port number to use for a TCP connectivity check.
Click OK to save your changes back to the ZyWALL.
Click Cancel to exit this screen without saving.
Chapter 13 Interfaces
359