Configuring An Active-Passive Mode Monitored Interface - ZyXEL Communications ZyWALL USG 300 User Manual

Table 190 Configuration > Device HA > Active-Passive Mode (continued)
LABEL
Password
Auto
Synchronize
Interval
Next Sync Time
Apply
Apply & switch
to Active-
Passive Mode
Reset
39.4 Configuring an Active-Passive Mode
Monitored Interface
The Device HA Active-Passive Mode Monitored Interface Edit screen lets
you enable or disable monitoring of an interface and set the interface's
management IP address and subnet mask. To access this screen, click
Configuration > Device HA > Active-Passive Mode > Edit.
If you configure device HA settings for an Ethernet interface and later add the
Ethernet interface to a bridge, the ZyWALL retains the interface's device HA
settings and uses them again if you later remove the interface from the bridge. If
the bridge is later deleted or the interface is removed from it, Device HA will
recover the interface's setting.
ZyWALL USG 300 User's Guide
DESCRIPTION
Enter the password used for verification during synchronization. Every
ZyWALL in the virtual router must use the same password.
If you leave this field blank in the master ZyWALL, no backup ZyWALLs
can synchronize from it.
If you leave this field blank in a backup ZyWALL, it cannot synchronize
from the master ZyWALL.
Select this to get the updated configuration automatically from the
specified ZyWALL according to the specified Interval. The first
synchronization begins after the specified Interval; the ZyWALL does
not synchronize immediately.
When you select Auto Synchronize, set how often the ZyWALL
synchronizes with the master.
This appears the next time and date (in hh:mm yyyy-mm-dd format)
the ZyWALL will synchronize with the master.
This appears when the ZyWALL is currently using active-passive mode
device HA. Click Apply to save your changes back to the ZyWALL.
This appears when the ZyWALL is currently configured for legacy mode
device HA. Click Apply to save your changes back to the ZyWALL and
set it to use active-passive mode device HA.
Click Reset to return the screen to its last-saved settings.
Chapter 39 Device HA
709