Log Setting Screens - ZyXEL Communications ZyWALL USG 300 User Manual

The following table describes the labels in this screen.
Table 255 Configuration > Log & Report > Email Daily Report
LABEL
Enable Email
Daily Report
Mail Server
Mail Subject
Mail From
Mail To
SMTP
Authentication
User Name
Password
Send Report
Now
Time for
sending
report
Report Items
Reset All
Counters
Apply
Reset

51.3 Log Setting Screens

The Log Setting screens control log messages and alerts. A log message stores
the information for viewing (for example, in the View Log tab) or regular e-
mailing later, and an alert is e-mailed immediately. Usually, alerts are used for
events that require more serious attention, such as system errors and attacks.
The ZyWALL provides a system log and supports e-mail profiles and remote syslog
servers. The system log is available on the View Log tab, the e-mail profiles are
used to mail log messages to the specified destinations. You can also have the
ZyWALL USG 300 User's Guide
DESCRIPTION
Select this to send reports by e-mail every day.
Type the name or IP address of the outgoing SMTP server.
Type the subject line for the outgoing e-mail. Select Append system
name to add the ZyWALL's system name to the subject. Select Append
date time to add the ZyWALL's system date and time to the subject.
Type the e-mail address from which the outgoing e-mail is delivered. This
address is used in replies.
Type the e-mail address (or addresses) to which the outgoing e-mail is
delivered.
Select this check box if it is necessary to provide a user name and
password to the SMTP server.
This box is effective when you select the SMTP Authentication check
box. Type the user name to provide to the SMTP server when the log is e-
mailed.
This box is effective when you select the SMTP Authentication check
box. Type the password to provide to the SMTP server when the log is e-
mailed.
Click this button to have the ZyWALL send the daily e-mail report
immediately.
Select the time of day (hours and minutes) when the log is e-mailed. Use
24-hour notation.
Select the information to include in the report. Select Reset counters
after sending report successfully if you only want to see statistics for
a 24 hour period.
Click this to discard all report data and start all of the counters over at
zero.
Click Apply to save your changes back to the ZyWALL.
Click Reset to return the screen to its last-saved settings.
Chapter 51 Log and Report
869