Wlan Interface Station Monitor Screen; Figure 173 Network > Interface > Wlan > Mac Filter > Add; Figure 174 Network > Interface > Wlan > Station Monitor; Table 72 Network > Interface > Wlan > Mac Filter - ZyXEL Communications 200 Series User Manual

Unified security gateway

Hide thumbs Also See for 200 Series:

Table of Contents

Chapter 10 Interface

If you set the filter to deny access and add the MAC address of a connected device, the

ZyWALL drops the device's connection immediately. However, if you set the filter to allow

only the specified MAC addresses, the ZyWALL does not immediately disconnect all

connected wireless clients.

To change your ZyWALL's MAC filter settings, click Network > Interface > WLAN >

MAC Filter > Add (or Edit). The screen appears as shown when you click Add. You cannot

edit the MAC address if you click Edit.

Figure 173 Network > Interface > WLAN > MAC Filter > Add

The following table describes the labels in this menu.

Table 72 Network > Interface > WLAN > MAC Filter

10.11 WLAN Interface Station Monitor Screen

The station monitor displays the connection status of the wireless clients connected to (or

trying to connect to) a IEEE 802.11b/g card installed in the ZyWALL. To open the station

monitor, click Network > Interface > WLAN > Station Monitor. The screen appears as

Figure 174 Network > Interface > WLAN > Station Monitor

The following table describes the labels in this menu.

Table 73 Network > Interface > WLAN > Station Monitor

Enter the MAC address (in XX:XX:XX:XX:XX:XX format) of the wireless station that is to

be allowed or denied access to the ZyWALL.

Enter a descriptive name for the MAC address entry.

Click OK to save your changes back to the ZyWALL.

Click Cancel to exit this screen without saving.

Select the location where the IEEE 802.11b/g is located.

Click this button to update the information in the screen.

This is the index number of the MAC address.

ZyWALL USG 100/200 Series User's Guide

Zywall usg 100 series