Ricoh AFICIO 1055 Operating Instructions Manual page 434

Troubleshooting
Messages
Paper mismatch. Load
<xxx> <yyy> paper in
<zzz>, or select another
tray and press [Continue].
Press [Reset] to cancel cur-
rent job.
3
Parallel Communication
Error.
Please set up communica-
tion parameters in parallel
menu.
Press [Reset] to cancel cur-
rent job.
Please open the bypass
tray.
Please wait.
Print overrun.
Press [Reset] to cancel cur-
rent job, or press [Continue]
to print.
Printer HDD Error.
Printer HDD cannot be
used.
18
Description
The paper size selected from
the host is not set in any trays,
when the tray selection is set to
"Auto Tray Switching".
There is no selected paper in
the selected input tray, al-
though the paper size has been
set from the host.
The actual paper size and input
tray are different from those se-
lected from the host.
A parallel communication error
has occurred during the print
job via the parallel port.
The bypass tray is not open.
The printer is warming up or
processing internally.
A print overrun occurred on a
file being printed. Only a part
of the data on the page will be
printed, and the print job is sus-
pended.
A Printer HDD error is detect-
ed while the power is on.
Comments
Put the correct paper in the tray,
and change the setting of the
tray using the control panel.
Press [Continue] to continue the
print job using the incorrect pa-
per.
When a length of time passes
without any key pressed, the
print job will be canceled auto-
matically.
<xxx>: Paper size
<yyy>: Media Type
<zzz>: Tray
Press [Reset] to cancel the cur-
rent job, and check the parallel
communication settings again.
Open the bypass tray.
Put the selected paper in the by-
pass tray, and the print job will
be resumed automatically.
Press [Exit] to cancel the current
job if you want.
Wait for the machine to get
ready.
Press [Continue] to ignore this er-
ror message, and the print job
will be resumed.
Press [Reset] to cancel the print
job.
When a length of time passes
without any key pressed, the
print job will be canceled auto-
matically.
To print the image correctly,
add memory to the machine, or
reduce the resolution of the im-
age and re-send the print job.
Press [Continue] after confirming
the error message, and the
printer will start without the
Printer HDD capability.