Table of Contents
Advertisement
ì
Click Apply.
The new settings will be sent to the base station.
Detailed description
"ISDN settings" on page 148
Further information
"Setting up channel bundling" on page 33
Setting dialling parameters
ì
Double-click Configuration in Folder List.
This displays the dialogues available.
ì
Click Dial settings.
The corresponding tabs are then displayed. You will now see the Dial parameters
tab.
ì
Define the dialling parameters you want to use with your base station.
– In the Int. access code field, enter International access code with up to 4 digits
for making calls abroad. The international access code 00 is preset.
– In the Country code field, enter the access code for your country with up to
2 digits. The country code is used for the correct assignment of your calls in inter-
national mobile telephone networks (GSM).
– In the Nat. access code field, enter an access code with up to 4 digits for making
calls to other national local networks. The access code 0 is preset.
– In the Dial parameter section, activate the option you want to use with your base
station. The default setting is Standard dial.
– In the Access code (SC) field enter the Access code with up to 4 digits to get an
outside line for all outgoing calls. There is no default access code in the factory
setting.
ì
Click Apply.
The new settings will be sent to the base station.
Detailed description
"Dial settings" on page 150
Further information
"Entering emergency numbers" on page 56
"Using the room monitor function" on page 57
"Configuring short message service (SMS)" on page 58
Configuring the base station
55
Advertisement
Table of Contents
