Getting to Know Your Copier
Access Number
If an access number has been programmed, it allows only particular
persons to use the copier or a supervisor to keep track of the number of
copies made by a particular department.
NOTE
è
If an access number has been programmed, a copy cycle can be
initiated only after the access number has been input to the copier.
Before you can use this function, you
must first turn "ON" the "Copy Track"
function of the Administrator mode
available from User's Choice,
see page 5-4.
Entering the Access Number
1
Using the 10-key pad, enter the 4-
digit access number and press the
OK key.
NOTE
è
To correct the 4-digit access number entered, first press the Clear key,
then enter the new number.
2
The touch panel changes from the "Access #" prompt to the initial
screen. A copy cycle can now be started. Make your copies as
necessary.
3
When the copy cycle is completed, press the Access mode key to go
to the "Access # Prompt Screen."
CF9001
1
2
3
4
5
6
7
8
9
0
C
2
2-15