The Copier Is Not Functioning As Designed - Minolta CF 9001 User Manual

7
7.2

The Copier is not functioning as designed

Symptom
The touch panel shows
nothing.
The Start key does not light
up green.
No copies are fed out when
the Start key is pressed.
Control panel keys do not
respond.
The copier is not activated
when the power switch is
turned ON.
If these procedures do not correct the problem, contact your Technical
Representative.
7-4
check for:
Is only the Start key lit up
green?
The display contrast control
knob is placed in the
excessively light or dark
position.
Is your Access number
entered?
The copier was just turned
ON and is warming up.
The copier has developed a
malfunction.
The Interrupt key LED is lit
up.
The power cord is left
unplugged from the power
outlet.
The room circuit breaker is
open.
Troubleshooting
Action
The copier is in the Energy
Saver mode.
Press any key on the control
panel to cancel the Energy
Saver mode, see page 2-13.
Viewing the touch panel, turn
the display contrast control
knob as necessary.
Enter your Access number,
see page 2-15.
It takes the copier about 9
minutes to be ready for
making copies after it has
been turned ON.
Please wait.
Check the touch panel and
take action according to the
message on the panel, see
page 6-25.
The copier is in the interrupt
mode.
Press the Interrupt key to
cancel the interrupt mode,
see page 2-14.
Plug the power cord into the
power outlet.
Close the room circuit
breaker.
CF9001