Before Using The Relay Broadcast Send Feature - Xerox WorkCentre M24 Reference Manual

4.2 Transmitting Documents Through a Relay Station (Relay Broadcast)
4.2.1
Before Using the Relay Broadcast Send
Feature
Before using the relay broadcast send feature, program the initiating stations and
relay stations in the Speed Dialing feature.
For details on how to register Address Numbers, see "9.3 Setting an Address Number" (P. 150).
Where
Initiating
station
4
Relay
station
44
G Fax Signal Method
G Assign the relay station to an Address Number (001 to 500) to set up the
relay broadcast send feature.
Program the Address Number of the initiating station (which is already
G
programmed at a relay station) as a relay station ID for the relay broad-
cast send operation.
G Program the Address Number or group numbers of the destinations
(which are programmed at a relay station) as broadcast receivers. The
wildcard "∗" can be used.
G DTMF method (G3)/F Code method
G No programming is required. The dialing format can be programmed in
speed dialing.
G Fax Signal Method
G Assign the initiating station to an Address Number from (001 to 099) and
set Relay Station Setup of the Address Number to On.
G Assign the destinations to Address Numbers from 001 to 099. The desti-
nations can be assigned using group dial numbers from the assigning sta-
tion.
DTMF method (G3)/F Code method
G
Assign the initiating station either an Address Number from 001 to 500
G
(when the specification method for the initiating station is 3 digits in F
Code) or 001 to 099 (when the specification method for the initiating sta-
tion is 2 digits in F Code). Then, set Relay Station Setup of the Address
Number to On.
Assign the destinations to Address Number. For the destination, assign
G
the relay station either an Address Number from 001 to 500 (when the
specification method for the initiating station is 3 digits in F Code) or 001
to 099 (when the specification method for the initiating station is 2 digits in
F Code).
What is required