Xerox WorkCentre M24 Reference Manual page 243

Item
Mode
Contents
Status
Total number of pages
Description
The mode used for the communication is shown here.
There are three modes; G3, EC and SG3 (Super G3). (This
field is blank if a mode other than these was used.)
The information about the communication is indicated here.
Refer to the Note field at the bottom of the report for a list of
abbreviations and their definitions.
ITransmitting
1 Remote service 2 Redial
Multi-Poll 5 Polling 6 Relay Broadcast
8 Fax forwarding box XXX
IReceiving
1 Mailbox XXX 2 Polling
4 Receiving line box XXX
box XXX
G XXX indicates the Mailbox number.
G Relay Broadcast is printed when Relay Broadcast and Relay
Broadcast Assignment are both specified at transmission.
The result of the operation is indicated here.
Normal .............The operation ended normally.
Busy .................The recipient is busy or did not answer.
Auto resend .....The document is being resent and the set
resend times has not been exceeded.
Terminated.......The communication was terminated.
Recipient check required .. An error caused by the recipient
or the line during communication.
Retransmission required ... Document must be retransmitted.
Re-reception required ....... Document
Cable check required ........ Check that the line is properly
XXX-XXX ........Error code
For details on lines, see "1.3 Telephone Line Connectors" (P. 4)
and for details on XXX-XXX (error code), see "11.2 Error Code
List" (P. 234).
All received pages are recorded.
10.8 Transmission Report
3 Mailbox XXX 4 Broadcast/
7 Relay Broadcast
3 Relay broadcast request
5 Transmitting telephone number
must be received
again.
connected.
10
219