Xerox WorkCentre M24 Reference Manual page 239

Item
No.
Doc.
Remote Station
Start Time
Duration
Pages
Mode
Description
The serial numbers for transmissions is shown.
Job numbers that the machine automatically assigned to
documents when the documents were received.
Information on recipient to which transmission is made is
recorded in the following order of priority.
ITransmitting (speed dialing)
1
Recipient
2
Remote terminal name
3
G3 ID (including spaces)
4
Tel No.
5
Communication mode EC (or G3, SG3)
ITransmitting (when all digits are dialed)
1
Remote terminal name
2
G3 ID (including spaces)
3
Tel No.
4
Communication mode EC (or G3, SG3)
IReceiving
1
Remote terminal name
2
G3 ID (including spaces)
3
Communication mode EC (or G3, SG3)
You can set the number of character digits displayed for the recipi-
ent. For details on setting up, see "9.8.4 Reports" (P. 184). The
factory set default displays the first 40 digits.
The date and time that the communication began are shown.
In Batch Send, the start time of the transmission for each
document is recorded.
The communication length is indicated. In Batch Send, the
length of time taken for a transmission for each document is
recorded.
"-" is indicated when the number of pages is 0.
ITransmitting
The number printed on the left side of the slash "/" indicates
the number of pages that were successfully transmitted. The
number printed on the right side of the slash "/" indicates the
number of total pages.In Manual Send, the number of total
pages is not shown.
IReceiving/Polling
The number of pages that the machine successfully received
is shown.
The mode used for the communication is shown here.
There are three modes; G3, EC and SG3 (Super G3). (This
field is blank if a mode other than these was used.)
10.7 Activity Report
10
215