Smart Array P400, P600 And P800 Controllers; Quick Installation Procedure - HP Integrity rx6600 User's & Service Manual

attempt is made to recover the operation. This may include clearing the fault condition by whatever
means necessary and retrying the operation.
DISABLEIR
The DISABLEIR command turns off IR functionality on a SAS controller. To accomplish the disabling,
set the MPI_IOUNITPAGE1_DISABLE_IR bit in the IO Unit 1 MPT Configuration page.
Syntax
cfggen <controller #> disableir
Parameters
This command does not require <controller #>.
Sample Output
Vendor Device
Index ID
----- ------
0 1000h 0054h
LOCATE
The LOCATE command turns locate LED's on and off.
Syntax
cfggen <controller #> locate
Parameters
<controller #>

Smart Array P400, P600 and P800 Controllers

The following information is provided to assist you in configuring the Smart Array P400, P600
and P800 controllers during installation. For additional information refer to the following documents:
HP Smart Array P400 Controller Support Guide
HP Smart Array P600 Controller for Integrity Servers User Guide
HP Smart Array P800 Controller for Integrity Servers User Guide

Quick Installation Procedure

To install the controller, follow these steps:
1. Power off the server.
2. Install additional physical drives if necessary (see
The number of drives in the server determines the RAID level that is auto configured when the
server is powered on.
3. Power on the server.
4. Update the controller firmware (see
process is complete, the server reboots and runs through a POST procedure. This POST
procedure halts briefly during controller initialization and prompts you to open ORCA (Option
ROM Configuration for Arrays).
5. Open ORCA. See
If using a headless console, press Esc+8.
Otherwise, press F8.
6. Configure the logical boot drive, and exit from ORCA.
Depending on the OS, additional device drivers and management agents must be installed. See
the User Guide for the specific HP Smart Array Controller at:
300 Core I/O Card Utilities
ID Bus Device
------ ---------
14h 08h LSI 1068 SAS Host Adapter
A SAS controller number between 0 and 255.
"Configuring the Array" (page
"Connecting External Storage" (page
"SAUPDATE Utility" (page
306).
301)). When the firmware update
301)).